Measuring bottom bracket signal implausible.
Note: Before working on the sensor plug, disconnect the Pendix ePower (battery) from the motor.
Check the plug for correct contact. Check the plug, the cable and the sensor for damage.
Replace the measuring bottom bracket as a test.
Note: The error check is carried out when the ePower is connected to the motor.

Note: In rare cases, the error may be caused by the speed sensor.
To check this, disconnect the speed sensor and contact the battery again.
Target: No error occurs without the speed sensor.
If this has occurred, check the 3 contacts of the speed sensor for a short circuit.
If all contacts indicate "open wire", the sensor is OK, otherwise it is defective.

If the error still occurs, please contact Pendix Service.